2-6
(3) For inverters with a capacity of 15 and 20 HP
To remove the terminal cover, first loosen the terminal cover fixing screw on it, and put your
finger in the dimple of the terminal cover (labeled "PULL"), and then pull it up toward you.
To remove the main circuit terminal block cover, hold the handles on the both sides of the main
circuit terminal block cover, and pull it up.
Figure 2.7 Removing the Covers (For Inverters with a Capacity of 15 and 20 HP)
When mounting the main circuit terminal block cover, fit it according to the guide on the
inverter.
Insert the main circuit terminal block cover by fitting the part labeled "GUIDE"
according to the guide on the inverter.
Push where "PUSH" are labeled to snap it into the inverter.
Figure 2.8 Mounting the Main Circuit Terminal Block Cover
(For Inverters with a Capacity of 15 and 20 HP)
To Next Page
Loading...
