Fuji Electric PXR4 - Parameter Setting Mode

– 14 –
Note:If the upper display (PV) comes off (or kept distinguished), make the setting once again by adding 64 to the set value of parameter DP13.
Switching by
the key
SEL
AL2AL1C1 C2 AL3
SEL
PXR-4
SV
PV
AL2AL1C1 C2 AL3
SEL
PXR-4
SV
PV
SEL
SEL
SEL
SEL
SEL
SEL
AL2AL1C1 C2 AL3
SEL
PXR-4
SV
PV
1
1
3
2
Press the
once.
Press the for 2 sec.
Parameter selection
Parameter setting procedure
Select a parameter you want to
set by pressing the or
key.
3
To shift to Operation/Standby
mode, press the key for 2 sec.
2-1
Press the key to allow the
parameter to change.
(Under the changing condition,
the parameter set value flickers).
2-2
Pressing the or key, to
change the parameter set value.
2-3
After the parameter has been
changed, press the key
for registration.
Parameter settings
Shift to operating condition
Parameter search.
Parameter change.
By repeating the same procedure, the
parameters can be displayed according to the
parameter list shown in 5, Setting methods of
temperature and parameters.
Operation mode
Parameter setting mode
Press the . Press the .
Increases parameter
set value
Decreases parameter
set value
Registers parameter set value,
returning to the parameter
shift mode .
1