EasyManua.ls Logo

Fuji Electric PXR4 - Specification

Fuji Electric PXR4
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
– 37 –
Specification
Power voltage: 100 (
-
15%) to 240V AC (+10%) 50/60Hz, 24V (±10%) AC/DC
Power consumption: 10VA or less (at 100V AC), 12VA or less (at 220V AC)
12VA or less (at 24V AC/DC)
Relay contact output: Control output 1: SPDT contact, 220V AC /30V DC 3A (resistive load)
Control output 2: SPST contact, 220V AC /30V DC 3A (resistive load)
SSR/SSC driving output *1: ON: 24V DC (17 to 25V DC)
(voltage pulse output) OFF: 0.5V DC or less
Maximum current ; 20mA or less
Resistive load 850 or more
4-20mA DC output: Allowable load resistor 600 or less
Alarm output (up to 2 outputs): Relay contact (SPST contact) 220V AC / 30V DC 1A (resistive load)
Heater disconnection alarm output: Relay contact (SPST contact) 220V AC / 30V DC 1A (resistive load)
Communication function *2: RS-485 interface
Transmission system ; Half-dueplex bit serial start-stop
synchronization
Transmission rate ; 9600bps
Transmission protocol ; In conformity to Modbus RTU or Z-ASCII
(PXR protocol)
Transmission distance ; Up to 500m (total length)
Connectable units ; Up to 31units
Digital input : Number of inputs; 2 inputs
Judged as ON : 3VDC or higher
Judged as OFF : 2VDC or lower
Input contact capacity ; 5V, 2mA DC
Input pulse width ; Min 0.5 sec
Re-transmission output: Output accuracy ±0.3% or lower
Permissible load resistance 600 or less
Remote SV input: Input accuracy ±0.5% FS or lower
(Without input break detection function)
Set resolution 3000 or higher
Input filtering function provided
Ambient temperature:
-
10 to 50°C
-
10 to 45°C (when side by side mounting)
Operating ambient humidity: 90%RH or less (no condensation)
Preservation temperature:
-
20 to 60°C
Time accuracy: Within ±0.5%
Voltage
Maximum current
SSR/SSC driving output
Allowable load
resistance for 4 to
20mA DC output
*1 : The following table shows the difference of outputs among other micro-controller X series models.
*2 : A communication converter is required to connect this product with PC.
Communication converter (recommended items) (option) :
• RC-77 (insulated type) manufactured by R.A SYSTEMS http://www.ras.co.jp
• SI-30A (insulated type) manufactured by LINE EYE http://www.lineeye.co.jp
• KS485 (non-insulated type) manufactured by SYSTEM SACOM http://www.sacom.co.jp
PXR3
PXR4/5/9
PXV3
PXV/W/Z
15V DC 20mA
24V DC 20mA
5.5V DC 20mA
24V DC 60mA
100 to 500
600 or less
600 or less
600 or less
Modbus RTU : A trademark of Modicon Corp.,USA

Related product manuals