51
INZ-TN2ZRE-E
Enter the password and then press the
ENT
key to enter the maintenance mode. The password can
be set by the password setting in maintenance mode. Default password setting at the time of de-
livery from the factory is “0000.” You can enter the maintenance mode with the value before the
password is changed.
Automatic OFF setting of the backlight of the LCD unit can be made.
When the specied time elapses from when the measurement screen is resumed, the backlight is
automatically turned off. Press any key to reset backlight OFF.
Only when ON is selected, the time until auto
OFF is displayed. Press the
key in this
state, and the time setting can be changed by
pressing the
or the key. Press the
ENT
key to conrm the selection.
If OFF is selected, the backlight is not turned
off.
Contrast of the LCD can be adjusted. The
contrast changes by pressing the
or the
key. Adjust to the best contrast and determine
it by the
ENT
key.
To Next Page
Loading...
