Fuji Xerox ApeosPort-IV 3070 User Manual

2 Product Overview
48
Product Overview
2
Finisher-B1 (optional)
No. Component Function
1 Tray attachment Install this attachment when delivering A4 or B5 paper to the
finisher tray without stapling.
For more information, refer to "Installing the Tray Attachment on Finisher-
B1" (P.69).
2 Booklet unit (optional) Staples creased outputs.
3 Booklet unit side cover Open this cover when replacing the booklet staple cartridge.
4 Booklet staple cartridge Contains staples. Remove this cartridge when replacing or adding
staples, or clearing staple jams.
5 Top cover Open this cover to clear paper jams.
6 Finisher tray Stapled or creased outputs are delivered here.
7 Creaser unit Creases outputs in half.
8 Staple cartridge Contains staples. Remove this cartridge when replacing or adding
staples, or clearing staple jams.
9 Front door Open this cover when clearing paper jams or replacing staples.
10 Front transport cover Open this cover when discarding punch scraps.
11 Hole punch waste container Collects scraps from the puncher.
12 US 2/3 Hole Punch Kit
(US standard) (optional)
2/4 Hole Punch Kit
(optional)
Punches holes in outputs.
Note • The distance between the two holes made with the US 2/3 Punch
Kit (US standard) is 70 mm, which is different from the 80 mm
distance made with the 2/4 Hole Punch Kit.
3
4
5
6
7
8
9
13
12
11
2
1
10

Fuji Xerox ApeosPort-IV 3070 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-IV 3070
Category	Copier
Language	English