Loading Paper
53
Paper and Other Media
4
Loading Tab Paper
Following describes the procedure for loading a tab paper in trays 3 to 4, tray 5 (bypass)
and the interposer.
Loading tab papers in trays 3 to 4
1 Pull out the tray towards you until it
stops.
Important • While the machine processes
a job, do not pull the tray out
that the job uses.
2 Push in both sides of the paper
guide levers, and slide them to their
new positions to accommodate the
size of index paper.
3 Make sure that the levers are
positioned correctly, and release
them.
4 Load and align the edge of the tab
paper against the right edge of the
tray with the side to be copied or
printed on facing down.
Important • Do not load paper exceeding
the maximum fill line (MAX in
the figure). It may cause paper
jams or machine malfunctions.
• Do not place any paper or
things in the empty space on
the right side of the tray. It may
cause paper jams or machine malfunctions.
Note • When copying or printing on multiple set of tab paper of a set with which tab positions differ,
load each tab paper with the side to be copied or printed on facing down to set the first paper
coming on top.
5 Move the two paper guide levers
while holding their grips so that they
lightly contact the edges of the
paper.
When pulling out the paper tray,
do it slowly. If pulled out with too
much force, the tray can hit and
injure your knees.
MAX
To Next Page
Loading...
Need help?
General
