Scanning Procedure
33
Basic Operation
3
Scanning Procedure
This section describes basic scan operations.The following shows the scan flow and
reference sections.
Step1 Loading Documents .........................................................................................................33
Step2 Selecting Features ............................................................................................................ 35
Step3 Starting the Scan Job........................................................................................................ 36
Step4 Confirming the Scan Job in the Job Status....................................................................... 37
Step5 Saving the Scanned Data.................................................................................................. 37
Step1 Loading Documents
There are two methods for loading documents:
Document feeder
z
Single sheet
z
Multiple sheets
Document Glass
z
Single sheet
z
Bound documents, such as books
Document feeder
The document feeder supports single sheet and multiple sheet documents, with sizes
ranging from 140 × 210mm (A5, A5 , 5.5 × 8.5 inches, 5.5 × 8.5 inches ) to a
maximum of 297 × 432mm (A3, 11 × 17 inches).
The document feeder can auto-detect only documents of standard sizes.For
documents that of not of a standard size, input the size in the [Scan Size] field.
The document feeder accept the following number of sheets.
Important • Place folded or creased documents on the document glass because they may cause paper
jams.
Document Type (weight)
Number of
Sheets
Lightweight paper (38-49g/m
2
) 250 sheets
Plain paper (50-81g/m
2
) 250 sheets
Heavyweight paper (81-128g/m
2
) 150 sheets
Heavyweight paper (129-200g/m
2
) 100 sheets
To Next Page
Loading...
Need help?
General
