Error Code
517
Problem Solving
16
133-280
133-281
133-282
133-283
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
133-700
O [Cause] The staple setting was cancelled.
[Remedy] Check the staple position, and try again.
133-710
O [Cause] When printing the received fax document, the paper
loaded on the bypass tray was used for printing because
the specified tray could not be used.
[Remedy] Take one of the following actions:
z
Load the printable paper for printing the received fax
document: A3SEF, A4LEF, B4SEF, B5LEF, A4SEF,
A5SEF, B5SEF, 8.5x11" SEF, 8.5x13", 8.5x14", 11x17",
8.5x11" LEF, 5.5x8.5" SEF.
z
Use the printable paper type for printing the received fax
document: plain paper, recycled paper, side 2 paper,
user-defined custom paper.
z
Check the settings by selecting [System Settings] > [Fax
Mode Settings] > [Fax Control] > [Receiving Paper Size].
1. Select [Receiving Paper Size] > [Tray Mode] to add the
tray to be used for printing the received fax documents.
2. Set up so that specified tray in [Tray Mode] can be used
for printing the received fax documents. If the error
persists, contact our Customer Support Center.
134-210
134-211
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
