Connectivity & Network Setup
157
Tools
5
îš„Primary Server IP Address
Enter the IP address of the primary server. Up to 255 characters are allowed. You can specify
the addresses by IPv4 address, IPv6 address, and FQDN.
îš„Primary Server - Port Number
Set the port number of the primary server. Set the primary server port number from 1 to
65535. The default value is 5060.
îš„Primary Server - Login User Name
Enter the login user name of the primary server. Up to 31 characters are allowed.
îš„Primary Server - Login Password
Enter the login password of the primary server. Up to 31 characters are allowed.
îš„Primary Server Type
Select the type of primary server from [Standard] or [Cisco].
îš„Secondary Server IP Address
Enter the IP address of the secondary server. Up to 255 characters are allowed. You can
specify the addresses by IPv4 address, IPv6 address, and FQDN.
îš„Secondary Server - Port Number
Set the secondary server port number from 1 to 65535. The default value is 5060.
îš„Secondary Server - Login User Name
Enter the login user name of the secondary server. Up to 31 characters are allowed.
îš„Secondary Server - Login Password
Enter the login password of the secondary server. Up to 31 characters are allowed.
îš„Secondary Server Type
Select the type of secondary server from [Standard] or [Cisco].
SIP Registrar Server Setup
Configure SIP registrar server settings. You can set a primary server and a secondary server.
Note • You can use up to two SIP registrar servers.
• Select [Cisco] for server type.
îš„Primary Server IP Address
Enter the IP address of the primary server. Up to 255 characters are allowed. You can specify
the addresses by IPv4 address, IPv6 address, and FQDN.
îš„Primary Server - Port Number
Set the primary server port number from 1 to 65535. The default value is 5060.
îš„Primary Server - Login User Name
Enter the login user name of the primary server. Up to 31 characters are allowed.
îš„Primary Server - Login Password
Enter the login password of the primary server. Up to 31 characters are allowed.
îš„Primary Server Type
Select the type of primary server from [Standard] or [Cisco].
îš„Secondary Server IP Address
Enter the IP address of the secondary server. Up to 255 characters are allowed. You can
specify the addresses by IPv4 address, IPv6 address, and FQDN.
îš„Secondary Server - Port Number
Set the secondary server port number from 1 to 65535. The default value is 5060.
îš„Secondary Server - Login User Name
Enter the login user name of the secondary server. Up to 31 characters are allowed.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
