5 Tools
158
Tools
5
Secondary Server - Login Password
Enter the login password of the secondary server. Up to 31 characters are allowed.
Secondary Server Type
Select the type of secondary server from [Standard] or [Cisco].
VoIP Gateway Setup
You can configure the following settings for VoIP Gateway 1 to 50.
You can also configure different VoIP gateways by a recipient’s telephone number.
Note • To use fixed VoIP gateway, do not register the ID, and specify only the IP address for VoIP
Gateway 1.
• You cannot use VoIP gateway in IPv6 network.
ID
Specify a number to identify the recipients’ telephone numbers.
If you specify "03", this VoIP gateway is used for the telephone numbers beginning with "03"
such as "0312345678" and "0312345679".
Note • If you specify a specific telephone number, specify the entire telephone number such as
"0312345678".
Gateway Address
Enter the IP address of the VoIP gateway.
T.38 Settings
Configure the settings for T.38.
T.38 Transport Protocol
Select T.38 transport protocol from [TCP] or [UDP].
Note • When you use VoIP gateway manufactured by Cisco Systems, Inc., select [UDP].
T.38 - UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
T.38 - TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
T.38 - RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
Prioritize T.38 IP Packets
Set the priority of IP packet transmission between 0 and 255.
Note • The value set varies depending on your environment. Consult your network administrator.
• Set the value already specified by the network side. If you set other values, the priority does
not change.
(For most of Cisco routers, speech traffic is set to 184(ef). If you change the value, consult
your network administrator.)
Downloaded From ManualsPrinter.com Manuals