5 Tools
164
Tools
5
îš„Maximum Number of Search Results
Set a maximum number of address to display from search results from 5 to 100. If the search
results exceed the maximum, the search stops at the maximum number set. The default
value is 50.
îš„Search Time-Out
Select whether or not to set a search time-out. Set the value from 5 to 120 seconds in 1
second increments.
îš„Directory Service for Address Book
Select whether or not to use an address book stored on the directory server.
Even when [Enabled] is selected, the address book of the directory server will not be started
unless the following conditions are satisfied.
z
The IP address of the directory server (primary) of the machine must be set.
z
The IP address or Internet address of the directory server (primary) must be set.
z
The port numbers used for LDAP communication must be set on the directory server and the
machine.
SMB Server Settings
îš„SMB Server Setup
Select the server specification method from [By Domain Name] and [By Domain & Server
Names/IP Address].
According to the option you selected here, set [Domain Name] and [Server Name/IP Address]
for SMB servers 1 to 5 respectively. The setting for SMB server 1 is used as the default
setting for authentication.
îš„Domain Name
Enter the domain name of the server. Up to 64 characters are allowed.
This setting is mandatory regardless of the SMB server specification method selected for
[SMB Server Setup].
Important • Use the NetBIOS or Active Directory domain name for the domain name.
îš„Server Name/IP Address
Enter the server name or IP address.
This setting is valid when [SMB Server Setup] is set to [By Domain & Server Names/IP
Address].
Important • Use the NetBIOS computer name or full computer name with DNS suffix for the server
name.
• For IPv4, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx" is a numeric value
from 0 to 255.
Security Settings
Set the security settings.
SSL/TLS Settings
Configure the SSL/TLS settings.
îš„Device Certificate - Server
Select a certificate for HTTP SSL/TLS communications.
îš„HTTP - SSL/TLS Communication
Select whether or not to enable HTTP SSL/TLS communications.
îš„HTTP - SSL/TLS Port Number
Set the port number used for HTTP SSL/TLS communication from 1 to 65535.
The default value is 443.
Important • Do not use the numbers assigned to the other ports.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
