Notes and Restrictions
601
Appendix
16
z
When IPv6 is enabled and IPv4 is disabled on the machine, you cannot specify a
storage location for the Browse function of the Scan to PC (SMB) service is not
available.
z
When the Scan to PC (FTP) service is used, only ASCII characters can be used for
file names.
z
In the following cases, since the addresses may not be recognized as those of the
same machine, the lpq command (for status check) and the lprm command (for
canceling) may not be available for LPD print jobs.
- When simultaneously operating IPv4 and IPv6 addresses with the same host
- When simultaneously operating multiple IPv6 addresses with the same host
z
IPv6 addresses may not be correctly recorded on job logs. Use an IPv4 network for
correct logging.
z
When searching a device outside the router via SMB, directly specify the address.
Multicasting is supported only within a local link (FF02::1).
z
In an IPv6 environment without a DNS server, if a computer name is specified in the
SMB server settings for SMB authentication, the authentication fails. Specify the
IPv6 address directly for a computer name of the authentication server.
Notes and Restrictions for USB Cable Distribution
This section describes notes and restrictions for USB cable distribution when using
HCF tray.
z
When you connect any device via a USB cable, ensure that the USB cable is not
distributed over the motor bracket in the rear of the HCF tray.
z
Distributing a USB cable over the motor bracket may cause the device to
malfunction.
USB Cable
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
