Connectivity & Network Setup
167
Tools
5
îš„IPSec Communication
Select whether or not to enable IPSec communications.
îš„IKE SA Life Time
Specify IKE SA lifetime from 5 to 28800 minutes in 1 minute increments.
Note • The value must be greater than the value set in [IPSec SA Life Time].
îš„IPSec SA Life Time
Specify IPSec SA lifetime from 300 to 172800 seconds in 1 second increments.
Note • The value must be smaller than the value set in [IKE SA Life Time].
îš„DH Group
Set DH group. Select from [G1] and [G2].
îš„PFS Settings
Select whether or not to enable PFS.
îš„Destination IPv4 Address
Set the IPv4 address of the destination.
When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx"
is a numeric value from 0 to 255.
îš„Destination IPv6 Address
Set the IPv6 address of the destination.
When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.
îš„Communicate with Non-IPSec Devices
Select whether or not to communicate with non-IPSec devices.
IEEE 802.1x Settings
Configure the IEEE 802.1x settings.
îš„IEEE 802.1x
Set whether or not to use IEEE 802.1x authentication.
îš„Authentication Method
Select from [EAP-MD5], [EAP-MS-CHAPv2], [PEAP/MS-CHAPv2], and [EAP-TLS].
îš„Login User Name
Enter the login user name with up to 128 characters.
îš„Login Password
Enter the login password with up to 128 characters.
îš„Server Certificate Verification
Select whether or not to verify a server certificate when [PEAP/MS-CHAPv2] is selected in
[Authentication Method].
Certificate Revocation Retrieval Settings
Configure the settings for certificate revocation retrieval.
îš„Level of Certificate Verification
Select a level of certificate verification from [Low], [Medium], or [High].
Selecting [Low] does not verify the validity of certificates.
Selecting [Medium] verifies the validity of certificates. If a certificate cannot be verified
because of a network error or any other problems, the certificate is determined as valid.
Selecting [High] verifies the validity of certificates, and determines only certificates that have
not been revoked as valid.
îš„Retrieval of Certificate Status
Select the method to verify the validity of certificates. Select [By Retrieving CRL] if the
machine retrieves a CRL (Certificate Revocation List) from the validation authority to verify
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
