EasyManua.ls Logo

Fuji Xerox DocuCentre-IV 3060

Fuji Xerox DocuCentre-IV 3060
633 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16 Appendix
586
Appendix
16
Notes on E-mail Receptions
A large volume of e-mail may not be printed if the memory capacity is insufficient. In
this case, increase the memory size or ask the sender to lower the resolution.
Notes on E-mail Reception when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, even if you receive
the split e-mail, you cannot reconstruct and print it.
Notes on E-mail Transmission when [Split by Data Size] is specified
When [Split by Data Size] is specified as the e-mail splitting method, split the data so
as to enable e-mail reception with e-mail software corresponding to the Message/
Partial content type.
Job Counter Report
If you specify multiple different [Pages per Side] settings using the Build Job feature,
the numbers of pages displayed for [2 Pages Up] and [Greater than 2 Pages Up]
displayed on the Job Counter Report are calculated according to the latest N-up setting
you specify.
Example 1:
When you select [2 Pages Up] for Document 1 (4 pages) and [Off] for Document 2 (2
pages), both Documents 1 and 2 are set to [Off] and the number of printed pages is
calculated as follows:
z
Total pages: 4
z
2 up: 0
Example 2:
When you select [Off] for Document 1 (4 pages) and [2 Pages Up] for Document 2 (2
pages), both Documents 1 and 2 are set to [2 Pages Up] and the number of printed
pages is calculated as follows:
z
Total pages: 5
z
2 up: 5
On ApeosWare Log Management or ApeosWare Accounting Service, the numbers of
pages for 2in1, 4in1, and 8in1 are also calculated in the same way as described above.
The meter on the [Billing Information] screen calculates the number of printed pages
correctly regardless of the [Pages per Side] setting.
Folder Passcode
z
You do not need to specify the passcode of a recipient when sending an IP Fax (SIP)
to a remote folder. Thus, the passcode enclosed in "\" or "/" is not replaced by "*" as
with that of regular faxes. If you select an IP Fax (SIP) by mistake and specify the
passcode of a recipient when you send a fax or an Internet fax, the passcode is
displayed on the touch panel screen, the Job Status screen, and a report. Be sure to
check the type of fax before sending a fax to a remote folder.
z
Communications and Information network Association of Japan (CIAJ) confirms the
use of image-/tiff-fx.
Downloaded From ManualsPrinter.com Manuals

Table of Contents

Other manuals for Fuji Xerox DocuCentre-IV 3060

Related product manuals