Density Uniformity Adjustment (Manual Process)
695
Appendix
16
8 Select [Confirm].
9 Check the sample output. If the color density is
uneven, make an adjustment.
1) Select the color to adjust from [Yellow],
[Magenta], [Cyan], and [Black].
2) Set the shape, level, and inboard / outboard,
according to the sample output.
Shape
According to the sample output, select how
the adjustment amount of the density pattern is from 1 to 10.
For details on shapes, refer to "Shape Patterns" (P.696).
Level
According to the sample output, select the difference level of density from 1 to 9. Level
shows there is no adjustment amount between the areas of the sample output. Greater
level shows greater difference.
Inboard / Outboard
According to the sample output, adjust the density pattern. Select the adjustment
amount from -17 to 17. Greater amount shows greater difference.
Input "+" value Input "-" value
Note • When the density pattern is not as shown above, adjust by [Shape] and [Level].
10 Print the sample output again to confirm the adjustment result.
11 Make adjustments again if necessary.
12 Select [Save].
13 Select [Close].
Darker
Lighter
Density
adjustment
amount
IN
OUT
Darker
Lighter
IN
OUT
Density
adjustment
amount
To Next Page
Loading...
