EasyManuals Logo
Home>Fuji Xerox>All in One Printer>DocuCentre-V C7785

Fuji Xerox DocuCentre-V C7785 Administrator's Guide

Fuji Xerox DocuCentre-V C7785
797 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
5 Tools
206
Tools
5
Important We recommend you to enable [HTTP - SSL / TLS Communication] under [SSL / TLS Settings] when
you use WebDAV. This is an effectual way to avoid password leaking.
Note You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine,
and then configure [Port Number] and [Operation Time-Out].
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important Do not use a number that is the same as a port number of another port. However, you can use the
same port number for a port that uses HTTP (PP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint print environment. The machine
decompresses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint
®
.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important Do not use any numbers assigned to the other ports.
Note ThinPrint is available when the communication protocol uses IPv4.
The maximum of three connections are possible at a time.
Protocol Settings
Set the parameters required for communications. [Protocol Settings] consists of the
following categories:
Ethernet Settings
TCP/IP - Common Settings
TCP/IP - Network Settings
Note To configure each category, select the corresponding item and then select [Change Settings].
Also on [Ping Connection Test], you can check whether or not the machine can be properly
connected to a network with the configured condition.
Ethernet Settings
Configure the Ethernet settings.
Ethernet1 - Network Name, Ethernet 2 - Network Name
When two Ethernet interfaces are used, specify the names respectively.
Note This item is displayed only when Secondary Ethernet (optional) is installed on the machine.

Table of Contents

Other manuals for Fuji Xerox DocuCentre-V C7785

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox DocuCentre-V C7785 and is the answer not in the manual?

Fuji Xerox DocuCentre-V C7785 Specifications

General IconGeneral
BrandFuji Xerox
ModelDocuCentre-V C7785
CategoryAll in One Printer
LanguageEnglish

Related product manuals