3 Maintenance
90
Maintenance
3
4 Insert the emptied hole punch waste container
into its original position until it stops.
5 Close the finisher front door.
Note • If the front door is not closed completely, a message appears and the machine will remain paused.
Emptying the Punch Scrap Container for Finisher D2-P with Booklet Maker
When the Finisher D2-P with Booklet Maker (optional) is installed and the punch scrap
container becomes full, a message appears on the touch screen. Discard the scraps
according to the message.
If you take the punch scrap container out of the machine, make sure to empty it completely.
If it is reinstalled with some scraps remaining, it may become full before the message
appears again, and this can cause machine breakdown.
Important • When emptying the punch scrap container, make sure that the machine is switched on. If not
switched on, the machine will not recognize that the punch scrap container has been emptied.
• When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power
Saver> button and the <Machine Status> button on the control panel before you empty the punch
scrap container.
• Before emptying the punch scrap container, press the <Machine Status> button and check the
current status for the punch scrap container even when the control panel is lit.
1 Make sure that the machine has stopped, and
open the right cover of the finisher.
2 Pull out the punch scrap container R4 towards
you.
To Next Page
Loading...
Need help?
General
