Replacing Consumables
91
Maintenance
3
3 Discard all the scraps.
4 Insert the empty punch scrap container into its
original position until it comes to a stop.
5 Close the right cover of the finisher.
Note • A message will be displayed and the machine will not operate if the right cover of the finisher is even
slightly open.
Replacing the Staple Scrap Container for Finisher D2-P with Booklet Maker
When the Finisher D2-P with Booklet Maker is installed and the staple scrap container
becomes full, a message appears on the touch screen. Replace the staple scrap container
according to the message.
Important • Replace the staple scrap container while the power is on.
• When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power
Saver> button and the <Machine Status> button on the control panel before you replace the staple
scrap container.
• Before replacing the staple scrap container, press the <Machine Status> button and check the
current status for the staple scrap container even when the control panel is lit.
Note • A staple scrap container is included in a Staple Cartridge for 100 sheets XF.
1 Make sure that the machine has stopped, and
open the right cover of the finisher.
Be careful not to get injured by waste staples when detaching a staple dust box.
To Next Page
Loading...
