7.9 Adjusting Color Density 197
12. After entering the values, press the <Eject/
Set> button to confirm your entry.
13. When adjusting the density of other colors,
return to Step 9 by pressing the < > button
and repeat the same steps.
14. When you are finished with the settings,
press the <Menu> button to return to the
print screen.
After changing the density settings for all colors, reprint the Calibration Chart using the
procedure in "Printing the Calibration Chart" (P. 193).
If you are not satisfied with the result, perform the calibration again.
[Process Gray] is gray made by mixing CMY toners. If the calibration was performed
successfully, the process gray should be close to black.
If either one of colors in CMY is stronger than the others, perform calibration again for that
color.
Cyan
L= 0,M= 0,H=-2*
To Next Page
Loading...
Need help?
General
