Fuji Xerox DocuPrint C3055

40 2 Basic Operation
2.4 Setting/Exiting the Power Saver Modes
The printer has a power saving feature which reduces power consumption during periods
of inactivity. This feature operates in two modes: the Low Power mode and Sleep mode.
As delivered, the printer switches to the Low Power mode 3 minutes after the receipt of the
last print request. The printer then switches to the Sleep mode after another 5 minutes of
inactivity.
In the Low Power mode, the display shows [Ready/Standby].
In the Sleep mode, all lamps on the control panel except for the <Power Saver> button go
out. The display also goes blank and displays nothing.
The factory default settings of 3 minutes (Low Power mode) and 5 minutes (Sleep mode)
are changeable within the range of 1 - 60 minutes (Low Power mode) and 1 - 120 minutes
(Sleep mode). The printer consumes less than 4 W in the Sleep mode, and returns to the
ready-to-print state in about 30 seconds when re-activated.
Note
• You can program your printer to disable the Sleep mode unless you are using one of the models
available in China. The Sleep mode cannot be disabled on the Chinese models.
• For more information about the Low Power and Sleep modes and how to change their settings, refer to
"Setting Example: Changing the Power Saver Mode Setting" (P. 92).
Exiting the Power Saver Modes
The printer automatically exits the Power Saver modes if it receives a print job from a
computer.
To manually exit the Low Power mode, press any button on the control panel. To exit the
Sleep mode, press the <Power Saver> button.
Note
• When the printer is in the Low Power mode, opening and closing a cover will cause the printer to exit the
Low Power mode.
• When the printer is in the Sleep mode, all buttons on the control panel except for the <Power Saver>
button do not function.
To use the buttons on the control panel, press the <Power Saver> button to exit the Sleep mode.