Error Message
185
Problem Solving
9
Error Message
This section describes how to solve the problem when an error message appears.
Important • The message displayed may vary depending on each error.
Error Message Cause and Remedy
A fault has occurred.
Switch the machine Off and then
On.
If the trouble persists, call for ser-
vice.
XXX-XXX
[Cause] A fault has occurred.
[Remedy]Turn the power off and wait for a while (5 sec.
or more) after the display of the control panel
goes out, then turn the power on again.
If the message persists, record the displayed
contents [XXX-XXX].
Turn the machine off immediately, wait until the
touch screen goes out, and then contact your
Fuji Xerox Customer Support Centre.
A fault has occurred.
Press [Restart] to start recovery.
If the trouble persists, call for ser-
vice.
XXX-XXX
[Cause] A fault has occurred.
[Remedy]Press the [Restart] button on the touch screen.
If the trouble still persists, turn the power off and
wait for a while (5 sec. or more) after the display
of the control panel goes out, then turn the
power on again.
If the message persists, record the displayed
contents [XXX-XXX].
Turn the machine off immediately, wait until the
touch screen goes out, and then contact your
Fuji Xerox Customer Support Centre.
Fault/Error
A fault has occurred.
Switch the machine Off and then On.
If the trouble persists,call for service.
XXX-XXX
Fault/Error
A fault has occurred.
Please press Restart to recover.
If the trouble persists, call for service.
XXX-XXX
Restart
To Next Page
Loading...
Need help?
General
