1 Before Using the Machine
42
Before Using the Machine
1
3 Pinching the lever at the end of the shaft (1),
remove the shaft from the core of the roll media
(2).
Note • Pinching the lever releases the lock of the roll
media, and you can remove the shaft.
4 Pinching the lever at the end of the shaft (1),
insert the shaft into the new roll media so that it
aligns with the media size guide (2).
Important • When setting a roll media with the shaft, place
the roll on the flat floor to avoid possible falling.
5 Adjust the roll media's orientation so as to place
the shaft on the shaft guide of the tray.
6 Rotate the roll media until the lead edge is
securely inserted into the bottom of the roller.
The roll media is automatically loaded, and
stops.
Important • If the roll media cannot be loaded properly
because its lead edge is damaged, trim the
lead edge of the media with your cutter knife
before setting it in place.
7 Press the cutter button to trim the lead edge of
roll media.
The lead edge of the roll media is trimmed.
Note • Pressing the cutter button once trims the paper
at 150 mm in length. When the cutter button is
held down, the roll media is continuously fed
until the cutter button is released. The roll
media is trimmed at the point that the cutter
button is released.
8 Remove the piece of paper that was trimmed.
To Next Page
Loading...
Need help?
General
