15
frequency identification tracking systems for assembly lines
and in other similar applications.
■ To prevent interference with the above devices, observe the
following precautions�
Confirm that the radio-frequency identification transmitter is
not in operation before using this device. If you notice that this
device causes interference in low-voltage radio-frequency
identification tracing systems, contact a Fujifilm representative.
■ The following may be punishable by law:
– Disassembly or modification of this device.
– Removal of device certification labels.
Cautions on Handling INSTAX MINI Instant Film and Prints
See below for film activities to be avoided.
Bluetooth® Devices: Cautions
IMPORTANT: Read the following notices before using the
product’s built-in Bluetooth transmitter�
■ Use only as part of a Bluetooth network�
Do not use in applications requiring a high degree of reliability,
for example in medical devices or other systems that may
directly or indirectly impact human life. When using the device
in computer and other systems that demand a greater degree
of reliability than Bluetooth networks, be sure to take all
necessary precautions to ensure safety and prevent
malfunction. FUJIFILM Corporation and its affiliates do not
accept liability for damages resulting from unauthorized use.
■ Use only in the country in which the device was purchased�
This device conforms to regulations governing Bluetooth
devices in the country in which it was purchased. Observe all
location regulations when using the device. FUJIFILM
Corporation and its affiliates do not accept liability for problems
arising from use in other jurisdictions.
■ Wireless data (images) may be intercepted by third parties�
FUJIFILM Corporation and its affiliates are not responsible for
intercepted transmissions, or for unintended image uses.
■ Do not use the device in locations subject to magnetic fields,
static electricity, or radio interference�
Do not use the transmitter in the vicinity of microwave ovens or
in other locations subject to magnetic fields, static electricity, or
radio interference that may prevent reception of wireless
signals. Mutual interference may occur when the transmitter is
used in the vicinity of other wireless devices operating in the
2.4 GHz band.
■ The Bluetooth transmitter operates in the 2�4 GHz band� The
maximum radio-frequency power is 9.10 mW�
■ This device operates on the same frequency as commercial,
educational, and medical devices and wireless transmitters�
It also operates on the same frequency as licensed transmitters
and special unlicensed low-voltage transmitters used in radio-
To Next Page
