Outline
1
1-7
1-3) Servomotor
n Appearance of product
n How the nameplate looks
Flange
The servomotor is installed to the
machine on this side.
* The figure shows type GYC751DC1-C. The appearance
varies according to the motor capacity.
MODEL : GYC751DC1-CA
************************
Made in Japan
Type designation
Serial No.
Output shaft
The output shaft of the
servomotor rotates.
Encoder cable
Connect to CN2 of the servo
amplifier using the optional
cable or connector kit.
The wiring from the encoder
cable up to the servo
amplifier is called “encoder
wiring.”
Encoder
A 16-bit serial encoder is
housed on the side of the
servomotor opposite to the
load.
Frame
The frame supports the
output shaft of the
servomotor. The frame is
molded of resin.
Power cable
Connect to the servo amplifier using
the optional cable or connector kit.
The wiring from the power cable up to
the servo amplifier is called “power
wiring.”
To Next Page
