INSTALLATION
2
2-3
(4) Handling
The servomotor is equipped with a built-in encoder. Do not hammer the output shaft of the
servomotor because the encoder is a precision device.
Do not support the encoder to lift the servomotor during installation.
The encoder built in the servomotor has been aligned with the servomotor. If it is disassembled, the
rated performance will not be obtained.
n Do not disassemble the servomotor.
If the servomotor is disassembled, the performance will deteriorate and the
mechanical system may be broken.
n Never give shocks to the servomotor by hitting with a hammer etc.
Otherwise the encoder will be broken, causing the servomotor to run away.
(5) Power supply to servomotor
Do not connect commercial power supply to the servomotor. Otherwise the internal magnet will be
de-energized to cause a failure of servomotor rotation.
For the connection method between the servomotor and servo amplifier, see chapter 3.
CAUTION
Encoder
To Next Page
