FujiFilm RYB751S3-VBC - Page 27

INSTALLATION
2
2-7
(3) Assembling the motor
While aligning the input shaft of the gear head with the key, insert the output shaft of the servomotor.
Tighten the screws of the gear head to fix the flange face of the motor to the flange face of the gear
input shaft.
After fixing the screws, tighten the hexagon socket head cap screw.
Plug the rubber cap in the original position as the last step.
Size of accessory screw
M4 x 4
Hexagon socket head cap screw
Type of gear head
GYN101CAG-G09, -G25
GYN201CAG-G09, -G25
GYN401CAG-G09, -G25
GYN751CAG-G09, -G25
Tightening torque
1.8 0.21 [N m]
GYN500SAG-G09, -G25
GYN101SAG-G09, -G25
GYN201SAG-G09, -G25
GYN401SAG-G09, -G25
GYN751SAG-G09, -G25
.
+_
Size of accessory
screw (quantity)
M4 x 12 (4 pcs.)
Screw size (For GYS)
Type of gear head
GYN500SAG-G09, -G25
GYN101SAG-G09, -G25
GYN201SAG-G09, -G25
GYN401SAG-G09, -G25
GYN751SAG-G09, -G25 M5 x 12 (4 pcs.)
Tightening torque
1.8 0.21 [N m]
3.5 0.42 [N m]
Size of accessory
screw (quantity)
M4 x 12 (4 pcs.)
Screw size (For GYC)
Type of gear head
GYN101CAG-G09, -G25
GYN201CAG-G09, -G25
GYN401CAG-G09, -G25
GYN751CAG-G09, -G25 M5 x 12 (4 pcs.)
Tightening torque
1.8 0.21 [N m]
3.5 0.42 [N m]
.
+_
.
+_
.
+_
.
+_