62
The DRIVE Button
Bracketing
Automatically vary settings over a series of pictures.
1
Press the DRIVE button to display drive options and press the se-
lector up or down to highlight one of the following:
Option
Description
AE BKT
Press the selector left or right to highlight a bracketing amount. Each time the shutter button is pressed,
the camera will take three shots: one using the metered value for exposure, the second overexposed by
the selected amount, and the third underexposed by the same amount (regardless of the amount selected,
exposure will not exceed the limits of the exposure metering system).
ISO BKT
Press the selector left or right to highlight a bracketing amount. Each time the shutter is released, the cam-
era will take a picture at the current sensitivity (P 75) and process it to create two additional copies, one with
sensitivity raised and the other with sensitivity lowered by the selected amount (regardless of the amount
selected, sensitivity will not exceed ISO 6400 or fall below ISO 200).
FILM SIMULATION
BKT
Each time the shutter is released, the camera takes one shot and processes it to create copies with the lm
simulation settings selected for X FILM SIMULATION BKT in the shooting menu (P 97).
WHITE BALANCE
BKT
Press the selector left or right to choose the bracketing amount. Each time the shutter button is pressed,
the camera takes three shots: one at the current white balanced setting, one with ne-tuning increased by
the selected amount, and another with ne-tuning decreased by the selected amount.
DYNAMIC RANGE
BKT
Each time the shutter button is pressed, the camera takes three shots with di erent dynamic ranges (P 93):
100% for the rst, 200% for the second, and 400% for the third. While dynamic range bracketing is in e ect,
sensitivity will be restricted to a minimum of ISO 800; the sensitivity previously in e ect is restored when
bracketing ends.
2
Press MENU/OK to select the highlighted option.
3
Take photographs.
To Next Page
Loading...
