36 U41858-J-Z126-2-76
Menu control
Ê Press the MENU/ENTER button (3).
The main menu is opened. The menu item selected is highlighted.
Ê Use the UP and DOWN keys (4 and 5) to go to the required menu item.
Ê Select an item with the MENU/ENTER button (3). The list entry selected is
highlighted.
Ê Use the MENU/ENTER button (3) and the UP and DOWN buttons (4 and 5) to add
the settings to the list entries selected.
Ê Confirm each of your settings by pressing the MENU/ENTER button (3).
Ê Quit the list entry, the menu item and the menu using the AUTO/EXIT button (6).
Switching the monitor on
Ê Press the power button (1) to turn the monitor on.
Notes on the LCD Display
● While the on-screen display may shift, blink, or otherwise be disturbed just after the
power is turned on or the OS starts up/shuts down, this does not indicate a machine
failure, and the device may be used normally.
● While 1280 × 1024 is the native full-screen resolution, the LCD display is full screen for
all resolutions.
For resolutions other than 1280 × 1024, characters may be blurred and the thickness
of thin lines can be uneven.
This is because the full-screen display is made by digital interpolation of the low-res
output, not by physical magnification. This is not a machine failure, and the device may
be used normally.
● Although there might be some always-off dots or some always-on dots, this is accepted
as it is a natural characteristic of LCDs, not as a fatal imperfection. So use this device
normally.
To Next Page
Loading...
Need help?
General