FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Copyright 2019 FUJITSU LIMITED P3AM-8012-14ENZ0
32
2. Installation
This chapter describes the installation procedures for the power synchronized unit and the AC sensor unit.
Make sure to check "
Safety Precautions" (page 13) before installation.
Package Contents Check
Check the list of package contents in Table 4 and Table 5 to confirm that there are no missing parts.
If there are missing parts, contact your sales representative.
Table 4 List of package contents (power synchronized unit)
Table 5 List of package contents (AC sensor unit)
Preparation
Installation Area
■ Placement area
Refer to the placement area of the rack to install the power synchronized unit and the AC sensor unit.
■ Installation condition
Install the power synchronized unit and the AC sensor unit in an area that meets all the conditions described in
"
Instructions for installation" (page 13) of "Safety Precautions".
Package contents Quantity Note
Power synchronized unit 1 —
RS232C cable 2
1m
For ETERNUS DX/AF connection
Rack mount kit One set —
Safety Precautions 1 —
Read Me First 1 —
Package contents Quantity Note
AC sensor unit 1 —
AC sensor port connection cable 1
4m
For power synchronized unit connection
Branch connector 1 —
Rubber foot 4
This is not used when the AC sensor unit is installed in a
rack.
Rack mount kit One set —
To Next Page
Loading...
