Fujitsu ETERNUS AF S3 Series - Installing a Power Synchronized Unit

To Next Page

To Previous Page

2. Installation

Installing in a Rack

FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)

Installing a Power Synchronized Unit

This section describes how to install a power synchronized unit in a rack.

■ Checking the package contents of the rack mount kit

Check the following package contents to confirm that there are no missing parts. If there are missing parts, con-

tact your sales representative.

■ Procedure for installing a power synchronized unit

Procedure

1 Open the front and rear doors of the rack.

2 Attach the M6 cage nuts to the rear rack pillar.

• Attachment positions

Insert four M6 cage nuts in the 1st and 3rd holes above the power synchronized unit base line.

❏ L-shaped bracket: 2

Same for right and left.

❏ M3 flat head screw: 4

For attaching L-shaped brack-

ets

❏ M6 cage nut: 4

Used when the holes in the rack

pillars are square

❏ M6 cross recessed head screw

with captive washer: 4

❏ Blank panel: 1

(Rear rack pillars)

Base line of

power synchronized unit

1st position

3rd position

1U (power synchronized unit size)

Other manuals for Fujitsu ETERNUS AF S3 Series