Fujitsu ETERNUS AF S3 Series - Connection Procedure When Adding an ETERNUS DX;AF

To Next Page

To Previous Page

5. Adding a Connecting Device

Connection Procedure When Adding an ETERNUS DX/AF

FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)

Connection Procedure When Adding an ETERNUS DX/AF

This section describes how to connect the power synchronized unit when an ETERNUS DX/AF is added.

For details about ETERNUS DX/AF installation, connection, and settings, refer to one of the following manuals:

• ETERNUS AF S3 series All-Flash Arrays Configuration Guide (Basic)

• ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)

• ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays Configuration Guide (Basic)

• ETERNUS DX200F All-Flash Arrays Configuration Guide (Basic)

• ETERNUS DX S5 series Hybrid Storage Systems Configuration Guide (Basic)

• ETERNUS DX60 S4/DX60 S3 Hybrid Storage Systems Configuration Guide (Basic)

• ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Configuration Guide

(Basic)

• ETERNUS DX500 S4/DX600 S4, ETERNUS DX500 S3/DX600 S3 Hybrid Storage Systems Configuration Guide

(Basic)

• ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-

• ETERNUS DX60 S2 Disk storage system User's Guide -Installation-

■ Adding up to four ETERNUS DX/AF storage systems

The connection procedure when up to four ETERNUS DX/AF storage systems are added is described below.

Procedure

1 Set the required settings for power synchronization of the ETERNUS DX/AF storage systems that

are to be added.

For details about the ETERNUS DX/AF settings, refer to "Setting the ETERNUS DX/AF" (page 44).

2 Connect the ETERNUS DX/AF storage systems to the power synchronized unit.

An example of a connection between ETERNUS DX/AF storage systems and a power synchronized unit is

shown below.

For details about how to connect an ETERNUS DX/AF to the power synchronized unit, refer to "

Connecting to

the ETERNUS DX/AF" (page 57).

Adding the ETERNUS DX8900 S4 or ETERNUS DX8100 S3/DX8700 S3/DX8900 S3 must be performed by your

maintenance engineer. Do not attempt to add the ETERNUS DX8100 S3/DX8700 S3/DX8900 S3 by yourself.

Other manuals for Fujitsu ETERNUS AF S3 Series