2. Installation
Installing in a Rack
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Copyright 2019 FUJITSU LIMITED P3AM-8012-14ENZ0
34
Installing in a Rack
This section explains how to install a power synchronized unit and an AC sensor unit in a rack.
Make sure to check "
Safety Precautions" (page 13) before installing the power synchronized unit and the AC sen-
sor unit in a rack. Also refer to the manual that is provided with the racks.
Do
• If the power synchronized unit and the AC sensor unit are installed or disassem-
bled other than as described in this manual, device failure or electric shock may
occur.
• The power synchronized unit contains delicate components, and should be han-
dled gently. Do not drop or knock the power synchronized unit against the rack
during installation.
• Install the blank panels provided with the rack where no other devices are
installed.
• Especially for an enclosed rack with doors, or when multiple devices are to be
mounted and running, it is important to realize that the temperature inside the
cabinet will be considerably higher than that of the room. Make sure the rack
internal ambient temperatures do not exceed the environmental conditions for
temperature described in "
Specifications" (page 22). Failure to do so may damage
the power synchronized unit.
• When installing the power synchronized unit with other devices into the same
rack, the airflow of the device installed on and under the power synchronized unit
may interfere with each other and reduce the effect of device cooling. Make sure
to leave plenty of room between the devices if required. Failure to do so may dam-
age the power synchronized unit and lead to malfunction.
• Do not obstruct the air vents in the power synchronized unit.
To Next Page
Loading...
