Fujitsu ETERNUS AF Series - Components; Power Synchronized Unit; Figure 1.3 Components (Power Synchronized Unit)

Chapter 1 Overview
1.4 Components
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
24
1.4 Components
This section describes the names and usage of the various components for the power synchronized unit and
the AC sensor unit.
1.4.1 Power Synchronized Unit
Figure 1.3 shows the names and usage of the various components for the power synchronized unit.
Figure 1.3 Components (power synchronized unit)
AC IN port
For power cord (for AC power input) connection
RCI port
Not used
PWC ports (#0, #1, #2, #3 from left)
For ETERNUS DX/AF connection with
RS232C cables to a power synchronized unit
AC SENSOR port
- For AC sensor unit connection
with an AC sensor port connection cable
to a power synchronized unit
- For cascading two power synchronized units
with a cascade cable to the AC SENSOR port
on the second power synchronized unit
CASCADE port
For cascading two power synchronized units
with a cascade cable to the CASCADE port
on the first power synchronized unit
SENSOR ports (left: #0, right: #1)
For power cord (for AC sensor) connection
to detect the power status of a server UPS unit
POWER LED
Displays the power status of a power synchronized unit
POWER SENSOR LED
Displays the detection status of AC output from
a server UPS unit
POWER CONTROL LED
Displays the power status of the connected ETERNUS DX/AF
CHECK LED
Displays the starting status of a power synchronized unit