Fujitsu ETERNUS AF Series - Chapter 5 Adding a Connecting Device; Connection Procedure When Adding a Server

FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
65
Chapter 5
Adding a Connecting Device
Devices (servers, power synchronized units, and ETERNUS DX/AF storage systems) that are to be power
synchronized can be added during system operation.
This chapter explains how to connect a power synchronized unit when these devices are added.
Make sure to check "
Safety Precautions" (page 9) or the manual provided with the server or the ETERNUS DX/
AF before adding a device.
5.1 Connection Procedure When Adding a Server
This section describes how to connect the power synchronized unit to synchronize power with an added server.
For details about server installation, connection, and settings, refer to the manual provided with the server.
Procedure
1 Connect the server UPS unit for the added server to the power synchronized unit.
An example of a connection between server UPS units and a power synchronized unit is shown below.
For details about how to connect a server UPS unit to the power synchronized unit, refer to "4.4.1
Connecting the Server UPS Unit to the Power Synchronized Unit" (page 57).
Power synchronized unit
Server#0
Server#1
UPS unit for
Server#1
UPS unit for
Server#0
Power cord (for AC sensor)
(Must be obtained by customers)
Added server
SENSOR#1 port