ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
3
Preface
This manual provides operational information about Web GUI for the FUJITSU Storage ETERNUS DX60 S3/
DX100 S3/DX200 S3, ETERNUS DX500 S3/DX600 S3, ETERNUS DX8700 S3/DX8900 S3 Disk storage systems, and
Web GUI for the FUJITSU Storage ETERNUS DX200F All Flash Array (hereinafter referred to as "ETERNUS Web
GUI"). It should be used for reference when setting up, managing operations, and maintaining the FUJITSU
Storage ETERNUS DX60 S3/DX100 S3/DX200 S3, ETERNUS DX500 S3/DX600 S3, ETERNUS DX8700 S3/DX8900
S3 Disk storage systems, and the FUJITSU Storage ETERNUS DX200F All Flash Array (hereinafter referred to as
"ETERNUS DX" or "storage system").
Knowledge of UNIX or Windows® system management is required.
This manual is written for controller firmware versions V10L40 and later. (V10L25 and later when using the
ETERNUS DX60 S3. V10L32 and later when using the ETERNUS DX100 S3/DX200 S3, the ETERNUS DX500 S3/
DX600 S3, and the ETERNUS DX200F. V10L33 and later when using ETERNUS DX storage systems in a Unified
Storage environment.) Some of the functions herein may not be supported for firmware versions V10L31 and
earlier.
Thirteenth Edition
July 2015
Structure of This Manual
This manual consists of the following seven chapters and eight appendices.
● Chapter 1 System Management
This chapter describes system management.
● Chapter 2 Component Management
This chapter describes hardware maintenance.
● Chapter 3 Volume Management
This chapter describes volume management.
● Chapter 4 Connectivity Management
This chapter describes connectivity settings between the host and the ETERNUS DX storage systems.
● Chapter 5 RAID Group Management
This chapter describes RAID group management.
● Chapter 6 Thin Provisioning Pool Management
This chapter describes Thin Provisioning Pool management.
To Next Page
Loading...
Need help?
General