Chapter 4 Connection and Settings
4.2 Turning on the Power Synchronized Unit
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
50
4.2 Turning on the Power Synchronized Unit
Connect the power cord (for AC power input) to the power synchronized unit to turn on the power
synchronized unit.
Each power synchronized unit requires a power cord (for AC power input).
Power cords (for AC power input) must be obtained by customers.
• Do not handle the power plug with wet hands. Doing so may cause electric
shock.
• Do not damage or modify the power cord or the power plug. Heating, forced
bending, twisting, pulling, or placing heavy objects on the power cord or the
power plug will damage it, causing electric shock or fire.
• Do not wind power cords too tightly at the root of the power cord. Doing so
stresses the cords and may expose or snap the inner wires, which can lead to
electric shock or fire.
• Do not use the power cord or the power plug if it is damaged or the plug does
not snugly fit into the socket. Doing so may cause electric shock or fire.
• Do not use a power cord that does not satisfy the specifications of the power
synchronized unit and the AC sensor unit. Doing so may cause electric shock,
fire, or device failure.
• Use a dry cloth to remove all dust from plugs and power sockets. Not doing so
may cause electric shock or fire.
• Use only power sockets that have a ground. Failure to do so may cause electric
shock, fire, or malfunction.
To Next Page
Loading...
