Fujitsu ETERNUS AF Series - Setting the ETERNUS DX;AF; Figure 4.1 ETERNUS DX60 S4;DX100 S4;DX200 S4, ETERNUS DX500 S4;DX600 S4

Chapter 4 Connection and Settings
4.1 Setting the ETERNUS DX/AF
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
45
4.1 Setting the ETERNUS DX/AF
Perform the necessary settings for power synchronization by using the setting and maintenance program of
the ETERNUS DX/AF.
If the power synchronized unit and the ETERNUS DX/AF storage system are connected with a redundant
configuration, the operations during a power down are as follows:
• For the ETERNUS DX60 S4/DX100 S4/DX200 S4, ETERNUS DX500 S4/DX600 S4, ETERNUS DX60 S3/DX100
S3/DX200 S3, ETERNUS DX500 S3/DX600 S3, ETERNUS DX8100 S3, ETERNUS AF250 S2/AF650 S2, ETERNUS
AF250/AF650, ETERNUS DX200F, and ETERNUS DX60 S2/DX80 S2/DX90 S2
When the controllers for CM#0 and CM#1 both receive shutdown instructions, the shutdown process
starts.
• For the ETERNUS DX8700 S3/DX8900 S3
When the Service Controllers (SVC) for SVC#0 and SVC#1 both receive shutdown instructions, the
shutdown process starts.
■ ETERNUS DX60 S4/DX100 S4/DX200 S4, ETERNUS DX500 S4/DX600 S4, ETERNUS DX60 S3/
DX100 S3/DX200 S3, ETERNUS DX500 S3/DX600 S3, ETERNUS DX8100 S3, ETERNUS AF250
S2/AF650 S2, ETERNUS AF250/AF650, and ETERNUS DX200F
This section explains the setting items on the power synchronization setting screen for the ETERNUS DX60 S4/
DX100 S4/DX200 S4, ETERNUS DX500 S4/DX600 S4, ETERNUS DX60 S3/DX100 S3/DX200 S3, ETERNUS DX500
S3/DX600 S3, ETERNUS DX8100 S3, ETERNUS AF250 S2/AF650 S2, ETERNUS AF250/AF650, and ETERNUS
DX200F.
Figure 4.1 ETERNUS DX60 S4/DX100 S4/DX200 S4, ETERNUS DX500 S4/DX600 S4, ETERNUS DX60 S3/DX100
S3/DX200 S3, ETERNUS DX500 S3/DX600 S3, ETERNUS DX8100 S3, ETERNUS AF250 S2/AF650 S2,
ETERNUS AF250/AF650, and ETERNUS DX200F setup (Setup Power Management screen)