Fujitsu ETERNUS AF Series - Installing an AC Sensor Unit

Chapter 2 Installation
2.3 Installing in a Rack
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0
39
2.3.2 Installing an AC Sensor Unit
This section describes how to install an AC sensor unit in a rack.
■ Checking the package contents of the rack mount kit
Check the following package contents to confirm that there are no missing parts. If there are missing parts,
contact your sales representative.
Install the AC sensor unit in the same rack as the server UPS unit. When installing the AC sensor unit, the
length of the power cord (for AC sensor) that connects the AC sensor unit and the server UPS unit must be
taken into consideration.
❏ Shelf plate: 1 ❏ L-shaped bracket: 2
Same for right and left.
❏ M4 cross recessed head screw
with captive washer: 2
❏ M3 cross recessed head screw
with captive washer: 4
❏ M6 cage nut: 4
Used when the holes in the
rack pillars are square
❏ M6 cross recessed head screw
with captive washer: 4
❏ Blank panel: 1