2. Notes and Cautions When Using This Product
Notes Related to MetroCluster IP
Notes and Cautions When Using This Product
23
Notes Related to MetroCluster IP
Supported Model Combinations
MetroCluster IP is supported by an ETERNUS AX2100 (excluding the ASA model) and ETERNUS
HX2200 running ONTAP 9.7 or by all models (excluding the ETERNUS AX1100 and the ETERNUS
HX2100) running ONTAP 9.8 or later. Note that the models used for the cluster that are to be
installed must be the same model.
The supported combinations are noted in Table 3
. Unlisted combinations are not supported.
Table 3 List of Supported Combinations for MetroCluster IP
Notes When Using an Adapter Card for MetroCluster IP
If an adapter card (HXBCPA or AXDCPA) for MetroCluster IP is used and its speed is changed from
40GbE to 100GbE, the node must be restarted.
Notes on Designing FabricPool Configurations
FabricPool relocates data blocks to the cloud tier according to the specified policy, and you cannot
use only cloud tier data blocks to perform a recovery. Design a FabricPool configuration that
includes a backup operation.
Note that BlueXP only supports the parts related to CVO/FabricPool.
Notes on Subscription Models
If a subscription model contract is signed, some information must be registered in the SPF portal
after an aggregate is created. After signing the subscription model contract, provide the informa-
tion on the pool, storage system IP address, and login account to the SPF portal staff in charge of
the onsite setup.
Site A Site B Supported
AX1200 AX1200 Yes
AX2100 AX2100 Yes
AX2200 AX2200 Yes
AX4100 AX4100 Yes
AC2100 AC2100 Yes
HX2200 HX2200 Yes
HX6100 HX6100 Yes
To Next Page
Loading...
Need help?
General