4. Notes and Cautions for Optional Software
Notes When Using SnapCenter Plug-in for VMware vSphere (SCV)
Notes and Cautions When Using This Product
40
(2) Restart the vmware-vpxd (vpxd) service on the vCenter server, and then clear the previ-
ously stuck vCenter tasks.
When Adding an SVM Using SVM Management LIF in SCV
To add an SVM using SVM management LIF, the target aggregate must be added to [List of Aggre-
gates Assigned]. If the aggregate is not included in the list (aggr-list), the following error is dis-
played and the SCV restore process fails.
Example:
If this error occurs, use the "vserver modify" command to assign the aggregate specified/displayed
in the error message to the target SVM.
When Storage Systems Cannot Be Registered with Certificate Authentication
If certificate authentication is used when registering a storage system, the following error may occur
and the storage system cannot be registered in the SCV.
If this error continues, change the authentication method to credentials and then register the stor-
age system.
When Upgrading to SCV 5.0P2
• If a storage system is deleted and then registered again, an error occurs
When a storage system is deleted and immediately registered again, the following error may
occur and the registration fails.
Wait a few minutes and register (or update) the storage system again. If the registration fails
even after waiting for a while, contact Fujitsu Support.
• The volume list cannot be displayed
After upgrading to SnapCenter Plug-in for VMware (SCV) 5.0P2 or later, connections to SVMs fail
and the volume list may not be displayed.
For SCV 5.0 and later, HTTP and ONTAPI type applications must be added as user login methods
for ONTAP users who are allowed to access the SCV.
Use the "security login show" command to confirm that users can access HTTP and ONTAPI type
applications.
Reason: aggregate <Aggregate_Name> is not in aggr-list of Vserver <Vserver_Name>
Failed to add/update storage system information: Failed to connect to storage system (IP
address of the storage system). \ nThis instance has already started one or more requests.
Properties can only be modified before sending the first request.
This instance has already started one or more requests.
Failed to add/update storage system information: Failed to connect to storage system
<SVM_NAME_OR_IP_ADDR>. \ nInvalid credentials. Please check the username or password
To Next Page
Loading...
Need help?
General