2. Notes and Cautions When Using This Product
Notes and Cautions When Starting the ETERNUS AX/AC/HX
Notes and Cautions When Using This Product
17
5-4 Check the cluster configuration.
(1) If the cluster consists of two nodes, execute the "cluster show" command.
Make sure that Health and Eligibility are enabled (true).
(2) If the cluster consists of four or more nodes, execute the "storage failover show" com-
mand.
Make sure that Takeover Possible is enabled (true).
Checking the LIF Status after Rebooting the ETERNUS AX/AC/HX
After the ETERNUS AX/AC/HX is rebooted, LIFs my be migrated to failover ports. Confirm that the
LIFs are on the home ports.
Input
Example
cluster1::> cluster show
Node Health Eligibility
--------------------- ------- ------------
cluster1-01 true true
cluster1-02 true true
2 entries were displayed.
cluster1::>
cluster1::> storage failover show
Takeover
Node Partner Possible State Description
-------------- ------------- -------- -------------------------------------
cluster1-01 cluster1-02 true Connected to cluster1-02
cluster1-02 cluster1-01 true Connected to cluster1-01
cluster1-03 cluster1-04 true Connected to cluster1-04
cluster1-04 cluster1-03 true Connected to cluster1-03
4 entries were displayed.
cluster1::>
network interface show
cluster1::> network interface show -vserver vs0
Logical Status Network Current Current Is
Vserver Interface Admin/Oper Address/Mask Node Port Home
----------- ---------- ---------- ------------------ ------------- ------- ----
vs0
data001 down/down 192.0.2.120/24 node0 e0e true
data002 down/down 192.0.2.121/24 node0 e0f true
data003 down/down 192.0.2.122/24 node0 e2a true
data004 down/down 192.0.2.123/24 node0 e2b true
data005 down/down 192.0.2.124/24 node0 e0e false
data006 down/down 192.0.2.125/24 node0 e0f false
data007 down/down 192.0.2.126/24 node0 e2a false
data008 down/down 192.0.2.127/24 node0 e2b false
8 entries were displayed.
To Next Page
Loading...
Need help?
General