Notes and Cautions When Using This Product
38
4. Notes and Cautions for Optional Software
This chapter describes notes and cautions for optional software.
Cautions When Using SnapCenter
When Using SnapCenter Version 4.3.1
For SnapCenter Version 4.3.1, when the SVM of the ETERNUS AX/AC/HX is registered using the "Add
Storage System" menu, there are cases when the SVM of the ETERNUS AX/AC/HX cannot be regis-
tered.
If this issue occurs, perform the following action and register the SVM of the ETERNUS AX/AC/HX
again using the "Add Storage System" menu of SnapCenter.
• Set the SVM to be registered in SnapCenter with Admin LIF using ONTAP System Manager or CLI.
When Upgrading SnapCenter 4.4 to 4.6
During a SnapCenter Plug-in for Oracle (SCO) Plug-in upgrade, the services (spl.service and scc.ser-
vice) are restarted on the host.
When Using SnapCenter and SnapCenter Plugin for VMware vSphere (SCV)
To register SVMs from SnapCenter and SCV, management LIFs must exist in those SVMs. In addition,
an SVM name and the IP address of an SVM management LIF must be resolvable for both forward
and reverse lookups.
When Upgrading to SnapCenter 5.0
• SVMs with only FC enabled disappear from SnapCenter
In an environment that is upgraded to SnapCenter 5.0, SVMs enabled with only FC disappear
from the cluster and the following error message may appear.
After adding management LIFs in the SVM, perform a re-detection from SnapCenter. Note that
enabling management LIFs is not required.
This issue is fixed in SnapCenter Version 4.4.
Create CG snapshot'<SNAPSHOT_NAME>'failed:Error:The credentials for the storage
system<SVM_NAME>is not configured.
To Next Page
Loading...
Need help?
General