Fujitsu ETERNUS DX8700 S3 - Page 1011

Appendix B Factory Default List
B.6 Advanced Copy Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
1011
■ Modify REC Buffer
*1: The default value when the usage is "Send" or "Receive".
■ Create REC Disk Buffer
Storage System Information
Setting
Storage System Type
• When the controller firmware version is
"V10L40" or later
ETERNUS DX8700 S3/DX8900 S3
• When the controller firmware version is
"V10L3x" or earlier
ETERNUS DX500 S3/DX600 S3
Line Setting Connection Type Direct
Link Speed 1 (Mbit/s)
Path Settings Line Setting Cleared
Bandwidth Limit Settings Setting Mode Set the same Bandwidth Limit for all paths
Bandwidth Limit 0 (Mbit/s)
Screen Setting item Default value
Screen Setting item Default value
REC Buffer Setting List Usage Unused
Remote Storage Box ID Remote storage system Box ID (*1)
Size 128 MB (*1)
Forwarding Interval 1 sec. (*1)
Monitoring Time 5 min. (*1)
HALT Wait Timer 15 sec. (*1)
Advanced Setting I/O Priority Mode Enable (*1)
Immediate HALT Mode Enable (*1)
High Bandwidth Mode Enable (*1)
Screen Setting item Default value
Manual Setting Controlling CM Automatic
Encryption by CM Off
Advanced Setting Stripe Depth 64 KB