Fujitsu ETERNUS DX8700 S3 - Page 184

Chapter 1 System Management
1.12 Storage Migration Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
184
3 Click the [Next >>] button.
- The destination CA port being set for "PATH" is in the following conditions:
• The setting is not correct
• The mode is not "Initiator"
• The status is abnormal
• The same value is duplicated in the Storage Migration setting file
• The value is already used in a Storage Migration in execution.
• A CE number other than "CE0" is specified (for models other than the ETERNUS DX8700 S3/
DX8900 S3)
- The source LUN is in the following conditions:
• Invalid characters are input
- The value is not a decimal or hexadecimal number
- The value is a decimal number that exceeds 256
- The value is not a 4-digit or 16-digit hexadecimal number
• The source LUN is used redundantly in the Storage Migration setting file
- The destination volume is in the following conditions:
• Invalid characters are input
- The value is not a decimal or 4-digit hexadecimal number
• The volume number is out of range
• Not specified
• The status is abnormal
• The volume type is not "Standard", "WSV", "TPV", or "FTV"
• The destination volume is used redundantly in the Storage Migration setting file
• The destination volume is already used in a Storage Migration in execution
- The source World Wide Name (WWN) being set for "PATH" is in the following conditions:
• The number of characters is not 16
• The value is out of range
• The first character is "0" or all characters are "F"
• The same value is duplicated in the Storage Migration setting file
• When an error is detected in the script analysis
• An error screen is displayed when the obtained destination storage system information is in the
following conditions:
- Two or more source storage systems are specified in single "GROUP"
- The source storage system has other Storage Migration instance already started
- The source storage system status is not normal
- The source WWN being set for "PATH" does not exist
- The source LUN is in the following conditions:
• The source LUN does not exist.
• An unusable status is detected.
• The capacity exceeds that of the destination volume.