Fujitsu ETERNUS DX8700 S3 - Page 472

Chapter 4 Connectivity Management
4.5 Host Response Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
472
Recommended patterns of host responses
For the setting values, refer to "Default values for recommended patterns of host responses" (page 876).
For details on the parameters for this function, refer to "A.4.5.1 Add Host Response" (page 870)
.
For the factory default settings for this function, refer to "Appendix B Add Host Response" (page 999)
.
The procedure to add a host response is as follows:
Procedure
1 Click [Add Host Response] in [Action].
2 Specify the host response name and set each parameter.
Host Response Name Connection Environment
Solaris MPxIO Set this parameter to connect to an Oracle Solaris host and to use the OS standard
Multipath Driver (MPxIO).
HP-UX Set this parameter to connect to an HP-UX host.
AIX Set this parameter to connect to an AIX host.
AIX VxVM Set this parameter to connect to an AIX host and to use VERITAS Volume Manager
(VxVM).
VS850/SVC Set this parameter to connect to an ETERNUS VS850 Virtualization Storage or an IBM SAN
Volume Controller (SVC).
BS2000 Set this parameter to connect to a BS2000 host and to enable the LUN expand mode.
Default Set this parameter for any host connection environments that are not listed above.
• A host response has a recommended patterns which has been prepared for each OS type.
Refer to " Recommended patterns of host responses" (page 472)
for details.
Select "Default" in other host connection environments.
• The host response setting can be customized. Use this function to create a new host response.