86
■ fi-5000N Device Alarms
If one of the following messages are shown on fi-5000N Message display, it is likely that fi-5000N
has hardware problem. In this case, turn off the fi-5000N power and turn it on again. If the same
device alarm occurs, contact the store where you purchased fi-5000N or an authorized FUJITSU
scanner service provider.
Message LED
Buzzer
frequency
(Nothing is displayed) Blinks at 1 second
intervals
-
(Nothing is displayed) Blinks at 2 seconds
intervals
-
Memory Error
Restart the device
--
Failure of loading program.
Restart the device.
--
PCI Initial Error.
Restart the device.
-Once
(long)
MACROM Read Error
Restart the device
-Once
(long)
Hardware error of fingerprint sensor.
Restart the device.
-Once
(long)
Failure of fingerprint sensor initialization.
Restart the device.
-Once
(long)
Calibration of fingerprint sensor failed.
Restart the device.
-Twice
Network configuration failure.
Restart the device.
-Twice
To Next Page
Loading...
