Copyright 2011 – FUJITSU ISOTEC LIMITED
FP-1000 Installation Guide-2 1.1.0.0
29 of 57
3.2.4 Check serial number
(1) Load paper in the printer and then close the cover.
(2) Turn the power on while holding down the FEED button. Keep holding it down until printing starts.
(3) Release the FEED button after the following printout is output.
Special Mode
1.Test Print
2.Setup Menu
3.Hex Dump
4.Command Trace
5.Sample Print
6.End
<Set>
Press FEED button for the number of times
as the same as your selecting item, and
wait more than 1 second.
Paper feed direction
(4) Push the FEED button once and then wait a second for printing to start.
(5) When printing finishes, turn the power off.
* Depending on the model, the printout may be long.
When you would like to stop it during printing, press FEED button again.
Serial number
Firmware Number KA02041-Jxxx
Firmware Version 01A (0xxxxx)
123456
Memory Switch 1
Power On Status Enable
Receive Buffer 4KByte
Busy Condition Bufferfull
Receive Error ?Print
Auto LF Disable
DSR(#6)Reset Disable
INIT(#25)Reset Disable
USB Soft Reset Enable
Memory Switch 2
Cover Open Error Auto Recovery
To Next Page
Loading...
Need help?
General