Fujitsu FP-510 - AC Adapter and Thermal Roll Paper; AC Adapter Specifications

19 / 125
2. AC Adapter and Thermal Roll Paper
2-1. AC adapter
Only use the AC adapter specified below.
Manufacture: Asian Power Devices Inc.
Model No.: DA-36B24
Order No.: KA02951-0120
Input: 100 to 240V , 50-60Hz, 1.1A
Output: 24V , 1.5A
Warning: Only use authorized AC adapters.
Warning: Do not use any other bundled AC adapter other than designed
for this printer.
2-2. Paper specification (Thermal paper)
Be sure to use thermal roll paper that conform to the following specifications.
- Paper width: For paper 83mm wide, 83
0
-1.0
mm 80mm wide, 80
0
-1.0
mm
For paper 60mm wide, 60
0
-1.0
mm 58mm wide, 58
0
-1.0
mm
- Outside diameter: For paper 75 to 90µm thick, φ102mm or less
For paper 90 to 150µm thick, φ90mm or less
- Core diameter: For paper 75 to 90 µm thick, φ12±0.5mm (inside)
/φ18±0.5mm (outside)
For paper 90 to 150µm thick, φ25.4±0.5mm (inside)
/φ32±0.5mm (outside)
- Printed surface: Outside of the roll
- Treatment of end of paper: The roll paper must not be glued to the core. The
end of the paper must also not be folded back.
Caution: Do not use rolls that have rough sides or sides from which
pieces of paper extrude. Using such rolls could cause a printer
failure.
2. AC Adapter and Thermal Roll Paper