Fujitsu FP-510 - Page 40

39 / 125
How to attach the separator
Attach the separator at the rear hook for the axis.
Caution: Push the separator down until it engages with an audible click,
and confirm that the top of the separator is aligned
horizontally.
Caution: When using roll paper with a width of 58 or 60 mm, take care
not to set the separator at an angle.
Caution: When replacing the separator, set a paper width appropriate to
the print area, referring to Appendix C-3 Setting Up the
Printer" in Appendix C, "Special Modes."
Aligned horizontally
Rear hook for the axis