55 / 125
Then, press the FEED switch for one second or longer to accept the
selection. The printer enters cutter cleaning mode. The printer prints
the following and cuts the paper when it enters cutter cleaning mode:
(3) Open the top cover and remove the roll paper.
(4) Press the FEED switch to move the cutter to a position that will
facilitate cleaning, and then clean the cutter.
(5) After completing cleaning, reposition the roll paper, and close the top
cover.
1. Open Cover, and remove Roll Paper.
2. Push FEED switch to move Cutter to
the cleaning position.
3. When cleaning is completed, set
Roll Paper, and close Cover
To Next Page
Loading...
